Flow-optimised press connector system for drinking water installations in acc. with DIN 1988
and DIN 50930-6 as well as heating installations tested in acc. with DVGW worksheet W
534.Press connectorsSafe and fast processing without calibration of the pipe ends through
O-ring-free press technology in all dimensions. In this way widening or calibration of the
pipe-ends becomes superfluous and reduces the assembly times. The interaction between
aerodynamic radii and minimal cross-section narrowings ensure the lowest pressure losses in
press systems for multilayer pipes. This allows a smaller dimensioning of drinking water
installations and reduces the pipeline volume.SC-ConturAll sizes with SC-Contur - connections
which remain unpressed become visible when the system is filled. The SC-Contur is certified and
fulfils the requirements of DVGW worksheet W 534 point 12.14 connectors with forced
leakage.During leakage tests with water Viega guarantees the identification of unpressed
connections in the pressure range 0.1 MPa-0.65 MPa in the case of a dry leakage test with
compressed air or noble gases from 22 hPa-0.3 MPa.MarkingGreen dot on the press
connectionPipesRaxofix PE-Xc Al PE-Xcdimensionally stable oxygen-proof in acc. with DIN 4726
greyRaxofix PE-Xcflexible blackDimensionsPress connectors and pipesRaxofix-PE-Xc Al PE-Xc: d
16 20 25 32 40 50 63Raxofix PE-Xc: d 16 20Areas of application PE-Xc Al PE-XcDrinking
waterHeatingRainwaterCompressed airAreas of application PE-XcRainwaterDrinking waterUse of the
system for application areas other than those described here must be agreed with Viega Service
Center.Operating conditionsDrinking water installationsOperating temperature max. 70
°COperating pressure max. 1.0 MPaHeating installationsOperating temperature max. 80
°COperating pressure max. 1.0 MPaIrrelevant of the direction of flow mixed installations are
permitted.NoteThe DVGW test mark is only valid f